Hobart 500546 Airforce 700i 230-Volt Plasma Cutter can cut 3/8 to 5/8 inch steel if powered by an engine-driven welder with a 240-volt generator power outlet of 8,000 watts of more. Hobart 500546 Airforce 700i 230-Volt Plasma Cutter is made for increased comfort, more efficient cooling and economical replacement cutting tips.
Hobart 500546 Airforce 700i 230-Volt Plasma Cutter is made to withstand tough working environments and it is rated for 35% duty cycle at 104 degrees F. It provides peak performance power under variable input voltage conditions for consistent and cleaner ending cuts. Post-flow air cooling cools the torch and tip after cutting. Read more…
Features
- Built in Air Compressor
- No gas pressure settings for flame tuning needed
- More precise cut, thinner kerf, less slag to clean up
- Smaller heat-affected zone for less warping
- Cuts faster than oxy fuel
